Removal Procedure
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 311-1362 | Vacuum Gauge Gp | 1 |
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
- Release the system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Note: Cleanliness is an important factor. Before you begin the removal procedure, thoroughly clean the exterior of the components in order to prevent dirt from entering the internal mechanism.
- Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A) . Apply 138 kPa (20 psi). This procedure will pull a vacuum on the hydraulic system.
 | |
| Illustration 1 | g01397769 |
- Remove bolts (1) . Repeat this step for the opposite side of the machine.
 | |
| Illustration 2 | g01413659 |
Photo for illustration purposes only. | |
- Remove cover (2) .
- Remove tube assembly (6) .
 | |
| Illustration 3 | g01414858 |
 | |
| Illustration 4 | g01414867 |
- Disconnect tube assembly (3) , tube assembly (4) , tube assembly (5) , tube assembly (7) , and tube assembly (8) .
- Remove bolts (9) and remove control valve (10) .