160M and 160 Motor Grader Machine Systems Control Valve (Brake) - Install Caterpillar


Control Valve (Brake) - Install
`
1.1. Installation Procedure

Installation Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
311-1362  Vacuum Cap 


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.


Note: Check the O-ring seals for wear or for damage. Replace the components, if necessary.



    Illustration 1g01414454

  1. Position control valve (7) and install bolts (10).

  2. Connect tube assembly (9), tube assembly (8), and tube assembly (6).


    Illustration 2g01414446

  3. Install tube assembly (5) and tube assembly (4).

  4. Connect tube assembly (3).


    Illustration 3g01392674

  5. Position cover (1).

  6. Install bolts (2). Repeat this step for the opposite side of the machine.


    Illustration 4g01397769

  7. Remove Tooling (A).

End By:

  1. Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".

Information System: