| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 311-1362 | Vacuum Cap | 1 |
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
- Release the system pressure. Refer to Operation and Maintenance Manual, "System Pressure - Release".
Show/hide table
Illustration 1 g01397769 - Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply
138 kPa (20 psi) . This procedure will pull a vacuum on the hydraulic system.Show/hide table
Illustration 2 g01392674 - Remove bolts (2). Repeat this step for the opposite side of the machine.
- Remove cover (1).
Show/hide table
Illustration 3 g01414446 - Disconnect tube assembly (3).
- Remove tube assembly (4) and tube assembly (5).
Show/hide table
Illustration 4 g01414454 - Disconnect tube assembly (6), tube assembly (8), and tube assembly (9).
- Remove bolts (10) and remove control valve (7).
