VIMS Communicator Toolkit System Requirements Caterpillar


System Requirements
`
1.1. Requirements for Personal Computers
2.2. Recommended Configuration
3.2. Minimum Configuration

This section lists the equipment that is required in order to support the VIMS Communicator Toolkit.

Requirements for Personal Computers

  • Use Table 1 when you purchase new equipment.

  • Use Table 2 in order to determine if your existing equipment is sufficient to support the software.

Recommended Configuration

Table 1
Recommended Configuration    
Computer     IBM PC Compatible    
Processor     Pentium IV 2.4 GHz    
Memory     1GB RAM    
Hard Drive     1GB or greater available space    
Monitor     15 inch XGA (1280x1024)    
Operating System     Microsoft Windows 2000 SP4 or else XP SP2    
Network Connection     Ethernet port for connecting to network    
Device for Pointing     Built-in device or mouse    
Web Browser     Microsoft Internet Explorer 6.0 or a later version    

Minimum Configuration

Table 2
Minimum Configuration    
Computer     IBM PC Compatible    
Processor     Pentium IV 1.8 GHz    
Memory     512MB RAM    
Hard Drive     1GB or greater available space    
Monitor     14.1 inch XGA (800x600)    
Operating System     Microsoft Windows 2000 SP3 or else XP    
Network Connection     Ethernet port for connecting to network    
Device for Pointing     Built-in device or mouse    
Web Browser     Microsoft Internet Explorer 6.0 or a later version    

Information System:

VIMS Communicator Toolkit Setup
VIMS Communicator Toolkit Program Description
VIMS Communicator Toolkit Poll Parameters
CB22, CB24, CB32 and CC24 Utility Compactors Shipping the Machine
140M and 150 Motor Graders Engine Supplement Engine Oil Filter and Base - Remove and Install
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Case Drain Flow for Piston Motor (Axle Propel) - Test
CB22, CB24, CB32 and CC24 Utility Compactors Rollover Protective Structure (ROPS) - Foldable
PL1000E Communication ECM Modbus Master
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Case Drain Flow for Piston Motor (Drum Propel) - Test
279C, 289C and 299C Compact Track Loaders Reference Material
The Electronic Priming Pump for Machine Engines will not Prime{1258, 1263}
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
VIMS Communicator Toolkit Troubleshooting
160M and 160 Motor Grader Machine Systems Control Valve (Brake) - Remove
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Travel Speed - Check
160M and 160 Motor Grader Machine Systems Control Valve (Brake) - Install
VIMS Communicator General Information
14L Motor Grader Machine Systems Control Valve (Brake) - Disassemble
14L Motor Grader Machine Systems Control Valve (Brake) - Assemble
VIMS Communicator Connections
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Parking Brake - Test
CB34, CB34XW and CC34 Utility Compactors Cooling System Water Temperature Regulator - Replace
2007/11/05 A New Rotor Brake is Now Used on Reclaimer Mixers {3275, 5631}
CB34, CB34XW and CC34 Utility Compactors Engine Oil Level - Check