- Vibratory Soil Compactor
- CP54B (S/N: GP5263-UP; PM51-UP)
- CP56B (S/N: MP61-UP)
- CP68B (S/N: CM61-UP)
- CP74B (S/N: CP71-UP)
- CP76B (S/N: J761-UP)
- CS54B (S/N: G541-UP; 5M41-284,298-UP)
- CS56B (S/N: M561-UP; 507101-UP)
- CS68B (S/N: M681-UP)
- CS74B (S/N: B7M1-UP)
- CS78B (S/N: M781-UP)
- CS79B (S/N: CM71-UP)
- CP56B (S/N: MP61-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Reports have been received that the machines listed above display the active DTC listed in Table 1.
DTC for Machine Electronic Control Module (ECM) Module Identifier (MID) 39 | |
---|---|
Suspect Parameter Number (SPN) - Failure Mode Identifier (FMI) | Code Description |
1713 – 13 | Hydraulic Oil Filter Restriction Switch : Low - least severe (1) |
![]() | |
Illustration 1 | g06615426 |
Typical example |
The DTC occurs mainly on the machines used in cold environments and primarily when using Cat® HYDO Advanced 30 hydraulic oil.
Solution
AVSpare is aware of this problem, but an interim repair has not been defined.
![]() |
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. |
In the event of failure, ignore the warning message and continue to run the machine.
Note: The DTC is active until the machine warms up.