R2900 Load Haul Dump Radiator Core - Clean Caterpillar

To access the radiator for cleaning, perform the following procedure.

Show/hide table



Illustration 1	g00947412

1. Release latch (1) and open the grille at the rear of the machine.

Show/hide table



Illustration 2	g00947413

2. Remove pins (2) and (3) from the two steering oil cooler mounting brackets.

Show/hide table



Illustration 3	g00947414

3. Swing steering oil cooler (4) away from the radiator. This will allow access to the radiator for cleaning.

Show/hide table



Illustration 4	g00907092

4. You can use compressed air, high pressure water or steam to remove dust and other debris from the radiator core. However, the use of compressed air is preferred.

   Note: Care must be taken when you are using high pressure water. High pressure water can cause damage to the radiator. Using a water spray nozzle on the pressure washer which will disperse the water pressure is preferred.

5. After cleaning, swing the oil cooler back towards the radiator and install pins (2) and (3) .

6. Close the grille.

Reference: For the complete procedure for cleaning the radiator core, refer to Special Publication, SEBD0518, "Know Your Cooling System" for the machine that is being serviced.