IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Filter - Replace Caterpillar


Hydraulic System Oil Filter - Replace
`
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders [SEBU7018]
HYDRAULIC SYSTEM
FILTER GP
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Filter - Replace


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "AVSpare Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on AVSpare products.

Dispose of all fluids according to local regulations and mandates.




Illustration 1g00765498

The hydraulic filter is located on the right side of the machine.

  1. Use a strap type wrench to remove the filter element. Dispose of the used filter element properly.

  2. Clean the filter mounting base. Make sure that all of the used gasket is completely removed.


    Illustration 2g00101318

  3. Lubricate the gasket of the new filter element with clean hydraulic oil.

  4. Install the new filter element by hand. After the gasket contacts the filter mounting base, tighten the filter element by an additional 3/4 turn.

  5. Start the engine and run the engine at low idle. Inspect the hydraulic system for leaks.


    Illustration 3g00765515

  6. Maintain the oil level above the “ADD COLD” mark on the sight gauge. Add hydraulic oil, if necessary.

Information System:

IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Transmission Oil Filter - Replace
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Circuit Breakers - Reset
928G Wheel Loader Shipping the Machine
120H and 135H Motor Graders Air System and Brakes Parking Brake
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Fuses - Replace
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Specifications
928G Wheel Loader Secondary Steering
938G Wheel Loader and IT38G Integrated Toolcarrier Engine Starting with Auxiliary Start Receptacle - If Equipped
554 Forwarder and 574 Forwarder Engine Starting with Jump Start Cables
928G Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
928G Wheel Loader Starting Above 0°C (32°F)
966G and 972G Wheel Loaders Display Modules (Caterpillar Monitoring System)
793B Off-Highway Truck Steering System Steering Gear
966G and 972G Wheel Loaders Hydraulic System Oil - Change
793C and 793C XQ Off-Highway Truck Steering System Piston Pump (Steering)
793B Off-Highway Truck Steering System Steering Control Valve
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Engine Oil and Filter - Change
928G Wheel Loader Autoshift Control
12H, 140H, 143H, 160H and 163H Motor Graders Air System and Brakes Service Brakes
12H, 140H and 160H Motor Graders Air System and Brakes Service Brakes
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Fuel System Primary Filter (Water Separator) Element - Replace
561M Pipelayer Transmission Selector and Pressure Control Valve - Power Shift
966G and 972G Wheel Loaders Secondary Steering - If Equipped
793B Off-Highway Truck Steering System Relief Valve (Steering)