834B and 836 Landfill Compactor Transmission Oil Filter - Replace Caterpillar


Transmission Oil Filter - Replace
`


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "AVSpare Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on AVSpare products.

Dispose of all fluids according to local regulations and mandates.


  1. Operate the machine in order to warm the transmission oil.

  1. Park the machine on level ground. Lower the blade to the ground and apply slight downward pressure.

  1. Engage the parking brake. Stop the engine.



    Illustration 1g00275084

  1. Open both of the access doors behind the cab.



    Illustration 2g00281424

  1. Remove the filter housing drain plug and allow the oil to drain into a suitable container.

  1. Use a strap type wrench to remove the filter housing.

  1. Remove the used filter element from the filter housing. Dispose of the used element properly.

  1. Clean the drain plug, the filter housing, and the filter housing base with a clean, nonflammable solvent.

  1. Inspect the filter housing seal. Replace the seal if the seal is damaged.

  1. Insert the new filter element into the filter housing.

  1. Install the filter housing.

  1. Start the engine. Apply the service brake. Only use the right brake pedal.

  1. Slowly operate the transmission controls in order to circulate the oil.

  1. Move the transmission control to the NEUTRAL position. Engage the parking brake. Inspect the entire transmission system for leaks.

  1. Check the transmission oil level.

    Reference: Refer to Operation and Maintenance Manual, "Transmission Oil Level - Check" for the correct procedure.

  1. Close the access doors.

Information System:

834B and 836 Landfill Compactor Rollover Protective Structure (ROPS) - Inspect
834B and 836 Landfill Compactor Transmission Oil - Change
834B and 836 Landfill Compactor Hydraulic System Oil Level - Check
834B and 836 Landfill Compactor Hydraulic System Oil - Change
834B and 836 Landfill Compactor Steering Cylinder Bearings - Lubricate
834B and 836 Landfill Compactor Fuses - Replace
834B and 836 Landfill Compactor Fuel Tank Cap and Strainer - Clean
834B and 836 Landfill Compactor Fuel System Secondary Filter - Replace
834B and 836 Landfill Compactor Fuel System - Prime
834B and 836 Landfill Compactor Engine Oil (High Speed) and Oil Filter - Change - If Equipped
834B and 836 Landfill Compactor Ether Starting Aid Cylinder - Replace
834B and 836 Landfill Compactor Differential and Final Drive Oil - Change
CP-433C, CS-431C and CS-433C Paving Compactors Engine Starting with Jump Start Cables
834B and 836 Landfill Compactor After Starting Engine
D6R Track-Type Tractor Operation
D9R Track-Type Tractor Standard Torque for Worm Drive Band Hose Clamps
844 Wheel Dozer Tree or Brush Removal
834B and 836 Landfill Compactor Starting with Auxiliary Start Receptacle
834B and 836 Landfill Compactor Throttle Lock Control
561M Pipelayer Track Roller Frame Guides - Inspect
834B and 836 Landfill Compactor Refill Capacities
834B and 836 Landfill Compactor Caterpillar Reference Material
834B and 836 Landfill Compactor Power Guard Control
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Seat Belt Adjustment