834B and 836 Landfill Compactor Engine Oil (High Speed) and Oil Filter - Change - If Equipped Caterpillar


Engine Oil (High Speed) and Oil Filter - Change - If Equipped
`
834B and 836 Landfill Compactor [SEBU6696]
BASIC ENGINE
PAN GP-OIL
834B and 836 Landfill Compactor Engine Oil (High Speed) and Oil Filter - Change - If Equipped
834B and 836 Landfill Compactor Engine Oil and Filter - Change


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "AVSpare Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on AVSpare products.

Dispose of all fluids according to local regulations and mandates.


Your machine may be equipped with a high speed arrangement for changing the engine oil. The high speed arrangement allows the engine oil to be changed faster than the conventional method.




    Illustration 1g00038499

  1. Open the access door behind the cab.



    Illustration 2g00282732

  1. Remove the cap that protects the male coupler. Connect an oil pump to the fitting.

  1. Turn on the oil pump and withdraw the engine oil from the engine crankcase.



    Illustration 3g00274715

  1. Open the access cover on the right side of the machine.



    Illustration 4g00038497

  1. Use a strap type wrench to remove both of the used oil filter elements.

  1. Clean the filter mounting base with a clean cloth.



    Illustration 5g00101318

  1. Apply a thin film of clean engine oil to the sealing surface of each new filter element.

  1. Install the new filter elements hand tight. When the gasket contacts the filter base, tighten the filter by an additional 3/4 turn.



    Illustration 6g00282732

  1. Clean the end of the male coupler for the high speed arrangement. Connect an oil pump to the male coupler. Fill the crankcase with new oil.

    Reference: Refer to Operation and Maintenance Manual, "Lubricant Viscositites and Refill Capacities" for the type of lubricant and for the refill capacity.

  1. Clean the end of the male coupler and the cap that covers the male coupler. Install the cap.

  1. Start the engine and allow the oil to warm. Check the machine for oil leaks.

  1. Check the engine oil level.

    Reference: Refer to Operation and Maintenance Manual, "Engine Oil Level - Check" for the correct procedure.

Information System:

834B and 836 Landfill Compactor Ether Starting Aid Cylinder - Replace
834B and 836 Landfill Compactor Differential and Final Drive Oil - Change
834B and 836 Landfill Compactor Cab Air Filter - Clean/Replace
834B and 836 Landfill Compactor Coolant Conditioner Element - Replace
834B and 836 Landfill Compactor Circuit Breakers - Reset
834B and 836 Landfill Compactor V-Belts - Inspect/Adjust/Replace
834B and 836 Landfill Compactor Lift Control
834B and 836 Landfill Compactor Air Conditioner - Test
834B and 836 Landfill Compactor Transmission Direction and Speed Control
834B and 836 Landfill Compactor Parking Brake Control
834B and 836 Landfill Compactor Heating and Air Conditioning Control
834B and 836 Landfill Compactor Backup Alarm
834B and 836 Landfill Compactor Fuel System - Prime
834B and 836 Landfill Compactor Fuel System Secondary Filter - Replace
834B and 836 Landfill Compactor Fuel Tank Cap and Strainer - Clean
834B and 836 Landfill Compactor Fuses - Replace
834B and 836 Landfill Compactor Steering Cylinder Bearings - Lubricate
834B and 836 Landfill Compactor Hydraulic System Oil - Change
834B and 836 Landfill Compactor Hydraulic System Oil Level - Check
834B and 836 Landfill Compactor Transmission Oil - Change
834B and 836 Landfill Compactor Rollover Protective Structure (ROPS) - Inspect
834B and 836 Landfill Compactor Transmission Oil Filter - Replace
CP-433C, CS-431C and CS-433C Paving Compactors Engine Starting with Jump Start Cables
834B and 836 Landfill Compactor After Starting Engine