AccuGrade GPS (CD700) Avoidance Zone - Set Caterpillar


Avoidance Zone - Set
`

Note: The contents of the "Setup Menu" are configurable on the site. Depending on the "Operator Configuration" settings of your system and the machine settings, the number of items that are in the "Setup Menu" may vary. Refer to your site supervisor if a specific option is not available.

You can set the warning zone distance for avoidance zones using the "Avoidance Zone" dialog. This allows you to configure the distance from an avoidance zone when you need to be warned.

Perform the following steps in order to access the "Avoidance Zone" dialog.




    Illustration 1g01300179

  1. From the "Setup Menu – Configuration" dialog, press the down arrow key or the up arrow key until "Avoidance Zone" is highlighted.



    Illustration 2g01300180

  1. Press the "OK" key. A dialog that is similar to Illustration 2 appears.

    In this example, the dialog shows the default warning distance for a grader.

  1. Do one of the following.

    • Press the arrow keys in order to set the warning distance.

    • Press the "Default <value>" soft key in order to set the default warning distance for the selected machine type.

  1. Press the "OK" key in order to confirm the setting.

  1. Press the "Escape" Key in order to exit the "Setup Menu – Configuration" dialog. The changes take effect immediately.