16M Motor Grader Wheel Bearing Oil (Front) - Change Caterpillar


Wheel Bearing Oil (Front) - Change
`

------ WARNING! ------

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.



NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.

Dispose of all fluids according to local regulations and mandates.




Illustration 1g01414751
The wheel has been removed for ease of viewing.

The front wheel bearings are located on the inner side of each front wheel. Check/fill plug (1) is located on the housings of each front wheel bearing.

  1. Clean the surface around the check/fill plug.

  2. Remove the check/fill plug.

  3. Use a 1U-7683 Suction Gun in order to remove the oil from the housing for the wheel bearing.

  4. Add oil to the housing for the wheel bearing until the oil level is at the bottom of the opening for the check/fill plug. Refer to the following topics:

    • Operation and Maintenance Manual, "Lubricant Viscosities"

    • Operation and Maintenance Manual, "Capacities (Refill)"

  5. Install the check/fill plug.

  6. Repeat Step 1 through Step 5 for the other wheel bearing.

Information System:

CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Piston Motor Flushing Valve (Drum) - Test and Replace
VIMS Communicator Browser Interface
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Pump Synchronization - Test and Adjust
VIMS Communicator Specifications
2007/10/08 A New Main Power Relay and Starter Relay are Now Used {4493, 7499}
CB34, CB34XW and CC34 Utility Compactors Engine Oil and Filter - Change
AccuGrade GPS (CD700) Horizontal Guidance
AccuGrade GPS (CD700) Startup
AccuGrade GPS (CD700) Designs
AccuGrade GPS (CD700) Display Navigation
AccuGrade<SUP>&reg; GPS (CD700) Full Screen Messages
AccuGrade<SUP>&reg; GPS (CD700) Troubleshooting Techniques
14L Motor Grader Wheel Bearing Oil Sample (Front) - Obtain
Some Couplers for Skid Steer Loaders and Multi Terrain Loaders May Have Difficulty in Engaging Work Tools{6101, 6129}
Installation of the Power Shift Solenoid{5264, 5479}
C32 Engine for D11T Track-Type Tractors Configuration Parameters
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Compactors Propel System Piston Motor Flushing Valve (Axle) - Test and Replace
CB22, CB24, CB32 and CC24 Utility Compactors Operator Controls
140M and 150 Motor Grader Control Valve (Brake) - Remove
AccuGrade GPS (CD700) Vertical Guidance
CB22, CB24, CB32 and CC24 Utility Compactors Engine Starting
VIMS Communicator File Transfer
AccuGrade GPS (CD700) Text Items - Set
CB34, CB34XW and CC34 Utility Compactors Hydraulic System Oil Filter - Replace